Keysight / Agilent / HP 209A HP_209A 209A TMG Test Equipment
Keysight / Agilent / HP

Keysight / Agilent / HP 209A

Keysight / Agilent / HP logo

Keysight / Agilent / HP 209A


HP 209A OSCILLATOR

The 209A Oscillator is a small, lightweight, sine/square oscillator. Stable, accurate signals which can be synchronized with an external source are instantly available over a frequency range from 4Hz to 2MHz. Separate adjustable sine/square outputs are located on the front-panel. Distortion and flatness can be minimized at low frequencies by a rear-panel Low Distortion Mode switch. Sine wave output of 5 V (600-ohms); square wave output of 20 V (p-p) into 600-ohms

RANGES:
Frequency:
 4hz to 2MHz in 6 ranges
 
performance:
dial accuracy +/-3% or frequency setting.
 
flatness:
at max output into 600 ohm load:
 +/- 0.5% from 100hz to 300 KHz
 +/- 1% from 200kHz to 1MHz
 +/- 5% from 1MHz to 2MHz
 
below 100hz, +/- 1% in LF low distortion mode, +5/-1% in normal mode.
 
distortion is 0.1% from 200hz to 200kHz, degrading to 1% at the ends of the
frequency range. In LF low distortion mode, the degradation is only 0.2%
at the low end.
 
hum and noise: less than 0.01% of output.
 
output characteristics:
 
sine wave: 
 output voltage: 5V rms into 600 ohms, 10V open circuit. output can be
 floated up to +/- 500V peak between output and chassis ground.
 
 output impedance: 600 ohms
 output control: 20 dB range, continuously adjustable.
 output balance: greater than 40db below 20 kHz
 
square wave:
 output voltage: 20V pk-pk open circuit, symmetrical about zero. Output
 can be floated +/- 500V from chassis ground.
 rise and fall time: less than 50ns
 symmetry: +/- 5%
 output impedance: 600-900 ohms depending on setting of output control
 
external synchronization:
 sync impedance: 10 kohm
 sync output: sine wave in phase with output. amplitude into 1megohm
 shunted by 100pf is greater than 1.7V rms from 4hz to 50KHz, greater
 than 0.1V above 50KHz
 sync input: oscillator can be synchronized to external signal. for 5V
 rms input, sync frequency can be as much as +/- 7% away from set
 frequency. sync range is a linear function of sync voltage.
 
general:
 operating temperature: 0C to 55C
 storage temp: -40C to 75C
 pwer AC line 115V or 230V +/- 10%, 50 hz to 400Hz, less than 7W.
 
weight:
 net 6 lbs, shipping 8lbs.

[HP_209A]
Exec Time: 0.105385 Seconds Memory Usage: 4.083488 Megabytes